12-29-2022, 09:29 PM
Firmware Version: v1.0.3 Build005
Release Date: Dec. 9th, 2022
Changelog:
Hello,
My X-Sabre 3 is connected by LAN to a router with DHCP. Roon Core is on Nucleus+ connected to same LAN. Roon finds and sets up the X-Sabre and it plays beautifully, displays cover art, bit-rate, etc. Occasionally, seemingly after going into standby, the X-Sabre wakes, but then says "No Network"..... and behaves oddly. Roon can still play music using the X-Sabre, but the display just says "No Network". If I try to adjust settings on the X-Sabre, the X-Sabre then flashes a speaker with an X in it, and then the Roon volume drops to zero. I have tried turning off standby, no good. I fix this by turning the power off to the X-Sabre. When it restarts, it works fine for a while, but eventually it loses the network again.
Anyone else experience this? Ideas for fix?
Is there a way to fully power off the unit other than just standby by using the touch screen or remote? I can only seem to put it in standby.
Thank you,
Ted
Release Date: Dec. 9th, 2022
Changelog:
Hello,
My X-Sabre 3 is connected by LAN to a router with DHCP. Roon Core is on Nucleus+ connected to same LAN. Roon finds and sets up the X-Sabre and it plays beautifully, displays cover art, bit-rate, etc. Occasionally, seemingly after going into standby, the X-Sabre wakes, but then says "No Network"..... and behaves oddly. Roon can still play music using the X-Sabre, but the display just says "No Network". If I try to adjust settings on the X-Sabre, the X-Sabre then flashes a speaker with an X in it, and then the Roon volume drops to zero. I have tried turning off standby, no good. I fix this by turning the power off to the X-Sabre. When it restarts, it works fine for a while, but eventually it loses the network again.
Anyone else experience this? Ideas for fix?
Is there a way to fully power off the unit other than just standby by using the touch screen or remote? I can only seem to put it in standby.
Thank you,
Ted
