Singxter u2 with Matrix Element X -

[Joel_1297]

II2S connection is working... just not getting Native DSD 1024 thru...

Last 2 jumpers on the U2 are set to "ON"

Any ideas?

Thanks!

JJ

---

II2S connection is working... just not getting Native DSD 1024 thru...

Last 2 jumpers on the U2 are set to "ON"

Any ideas?

Thanks!

JJ

What port definition should I use?

[Wei Cao]

Hi JJ
The element X does not support DSD 1024.

[Joel_1297]

Hi JJ
The element X does not support DSD 1024.

HMMM

I thought is did support thru II2 S connection?  At least that is what is posted.

I have the Singxer U2.. which can output in native dad 1024

Do i use A or B ?

You have the jumper config on the Singxer u2 for the Element X ?  ( i currently have last 2 "on"
Thanks
JJ

[Wei Cao]

There are 4 pin definitions to compatible with IIS output devices. You may need to compare the pin definition disgram of element X with the one of Singxer U2.
Please find the definition diagram of element X in page 17 of the manual.
https://www.matrix-digi.com/pdf/element_X_Manual_EN.pdf

[Joel_1297]

Hello, Not sure where else to put this..

Wei, my Element X keeps losing connection with wireless internet.. have to plug out and back in , to reconnect... any recommendations?

---

Hi JJ
The element X does not support DSD 1024.

HMMM

I thought is did support thru II2 S connection?  At least that is what is posted.

I have the Singxer U2.. which can output in native dad 1024

Do i use A or B ?

You have the jumper config on the Singxer u2 for the Element X ?  ( i currently have last 2 "on"
Thanks
JJ

---

Hello, Not sure where else to put this..

Wei, my Element X keeps losing connection with wireless internet.. have to plug out and back in , to reconnect... any recommendations?