Hi there,
not sure if this is the right place to post but I'm struggling with my Element S... I have both Gustard x20Pro and x26Pro and cannot find a proper setting for the I2S port.
Just discovered that the x20Pro is not compatible since it needs at least 3.3V from pin 18 and the Element S does not offer this option.
I'm using it as Roon Endpoint.
I've found an "almost" suitable setting for the x26Pro.
This is the combo Type B and Mode B but works with DSD Native only, no way to play PCM... No matter which rate.
Do I need to reboot the streamer after I2S setting?
USB out works fine and so does Coax SPDIF (including DSD64 via DoP).
But in this case things are not flawless...
When I start playing any sample rate a POP/BUMP follows.
This happens even if I normalise all to the same sample rate using Roon DSP only with the very first song, then it goes obviously smooth.
Is there a way/safe workflow to avoid this?
Thanks!
not sure if this is the right place to post but I'm struggling with my Element S... I have both Gustard x20Pro and x26Pro and cannot find a proper setting for the I2S port.
Just discovered that the x20Pro is not compatible since it needs at least 3.3V from pin 18 and the Element S does not offer this option.
I'm using it as Roon Endpoint.
I've found an "almost" suitable setting for the x26Pro.
This is the combo Type B and Mode B but works with DSD Native only, no way to play PCM... No matter which rate.
Do I need to reboot the streamer after I2S setting?
USB out works fine and so does Coax SPDIF (including DSD64 via DoP).
But in this case things are not flawless...
When I start playing any sample rate a POP/BUMP follows.
This happens even if I normalise all to the same sample rate using Roon DSP only with the very first song, then it goes obviously smooth.
Is there a way/safe workflow to avoid this?
Thanks!
