, 04:12 AM
(这个帖子最后修改于: , 04:15 AM by Three Springs.)
Hi, I recently purchased Mini-I 4 Pro (great product). However, some questions:
1. I would like to listen to two headphones at once with a mate (HIFIMAN Deva Pro [18Ω 93.5dB] and HE560V4 [50Ω 90dB]) and noticed that the volume on both headphones (using 6.35 and 4.4) are quite different. Is there a way to control the volume of each headphone independently? I noticed here (6:27):
that the old Mini-i offered this function. What about the new Mini-i 4 Pro?
2. I have been using a male to two female 3.5 power splitter in the 6.35 jack to listen to both headphones at once. Lately, I’ve noticed that when connected to USB Audio (with USB-A), there would be the odd glitch or skip (I didn’t notice this for Airplay but havn’t tested it thoroughly). Because I have found this for youtube, foobar and iTunes, I’m guessing it’s from the Mini-I? Then, it started doing this even when I went back to a single headphone. Earlier today, I performed a software update and immediately after, listened to an album (with power splitter) for about 35 minutes with no problems. I paused it for 10 min, and when I resumed, it started skipping/glitching again.
Any help for a solution would be greatly appreciated.
1. I would like to listen to two headphones at once with a mate (HIFIMAN Deva Pro [18Ω 93.5dB] and HE560V4 [50Ω 90dB]) and noticed that the volume on both headphones (using 6.35 and 4.4) are quite different. Is there a way to control the volume of each headphone independently? I noticed here (6:27):
that the old Mini-i offered this function. What about the new Mini-i 4 Pro?
2. I have been using a male to two female 3.5 power splitter in the 6.35 jack to listen to both headphones at once. Lately, I’ve noticed that when connected to USB Audio (with USB-A), there would be the odd glitch or skip (I didn’t notice this for Airplay but havn’t tested it thoroughly). Because I have found this for youtube, foobar and iTunes, I’m guessing it’s from the Mini-I? Then, it started doing this even when I went back to a single headphone. Earlier today, I performed a software update and immediately after, listened to an album (with power splitter) for about 35 minutes with no problems. I paused it for 10 min, and when I resumed, it started skipping/glitching again.
Any help for a solution would be greatly appreciated.
