主题评价:
  • 0 次(票) - 平均星级: 0
  • 1
  • 2
  • 3
  • 4
  • 5
Click noise occurs when using an I2S connection with X-SPDIF 2 + X-Sabre Pro.
#1
I will post the details in a new thread.

Click noise occurs when switching the sampling rate when using with PC → USB → X-SPDIF 2 → I2S → X-Sabre Pro, MCLK ON and 128fs synchronous mode.
It does not occur at 44.1 and 48kHz. Click noise occurs when switching from 44.1 and 48kHz to 96kHz or more, or switching from 96kHz or more to 44.1 and 48kHz.
It does not occur in asynchronous mode.

The sound is overwhelmingly good in sync mode, so it would be very appreciated if improved.

I forgot to write it, but I am using XLR from X-Sabre Pro to connect to a headphone amplifier and listening with headphones.
So the click noise sounds loud and I am worried about the headphones and ears.
回复
#2
Hi Leaves,
our technical guy is trying to reproduce the pop noise you mentioned.
Please wait.

Thank you.
回复
#3
Hi,
Did you reproduce the noise?
Are there any plans to fix it in the future?

Thank you.
回复
#4
Sorry to let you wait so long time, today we began to work at office. we were work at home before today because the epidemics.
I will let you know the situation once i get some further information.
回复
#5
Hi,
I'll ask you again, can you just tell me if there are any plans to fix it?
Sound quality is the highest priority, so if you make a correction and it can cause sound quality degradation, you don't need to fix it.

Thank you.
回复


论坛跳转:


正在浏览该主题的用户: 1 个游客