+- Matrix Audio Community (https://www.matrix-digi.com/forums)
+-- 版块： Main Discussion（主讨论区） (https://www.matrix-digi.com/forums/forumdisplay.php?fid=1)
+--- 版块： English Discussion (https://www.matrix-digi.com/forums/forumdisplay.php?fid=4)
+--- 主题： Min-i Pro 3 and Vinyl Turntable (/showthread.php?tid=133)
Min-i Pro 3 and Vinyl Turntable - Pedro - 04-24-2021
I use my Vinyl Turntable Technics SL-D2 with a Thorens preamp and it has very good sound quality.
I tried to connect to Min-i Pro 3. Very poor pre-amplification and very bad sound quality. No bass and very low pre-amplification level. To hear at a normal sound level, I need to have my amplifier set to 80.
Someone with the same experience?
Is it a problem with my Min-i iPro3?
Regards
RE: Min-i Pro 3 and Vinyl Turntable - Wei Cao - 04-25-2021
Hi Pedro,
The mini-i pro 3 cannot replace a phono pre-amp. If the turtable only has a phono output without a lineout, it would not work with mini-i Pro 3 properly. Because the output amplitude is too low.
You can find the option Line-in Gain in settings menu of mini-i Pro 3, the input amplitude should not much lower than 1Vrms. To connecting to the analogue source which outputs amplitude is about 1Vrms, you can set the linein gain to +6dB. If the signal is much lower than 1Vrms, the +6dB would also not enough for you.
Regards.
RE: Min-i Pro 3 and Vinyl Turntable - Pedro - 04-26-2021
Thanks